Author Topic: Raspberry Pi turned into a portable workstation  (Read 885 times)

Offline javajolt

  • Administrator
  • Hero Member
  • *****
  • Posts: 36193
  • Gender: Male
  • I Do Windows
    • windows10newsinfo.com
Raspberry Pi turned into a portable workstation
« on: January 24, 2013, 12:36:27 AM »
The Raspberry Pi isn’t just a very cheap PC, it’s also tiny and uses very little power. So it isn’t too surprising to see one hooked up to a battery and display in a makeshift portable workstation.
 
SK Pang Electronics sell a wide range of gadgets and components, so when the Raspberry Pi got delivered they didn’t hang about experimenting with it. What they have done is combine a mini wireless keyboard typically used with a smartphone, a USB power pack, and an small LCD monitor usually found in the backseat of a car.
 
This project is a portable Raspberry Pi computer.
 
It uses standard off the shelf hardware. The LCD is a low cost TFT monitor used in car reverse camera. The monitor has a video input but the supply is 12v. This needs to be modify to accept 5v from the batter pack. The battery pack is a standard portable USB charger.



Modifying the LCD Monitor
 
The monitor requires a 12v input but the battery pack only gives out 5v. Inside the monitor there is a 5v regulator. This need to be by bypass and connect straight to the 5v line. The red supply wire is removed from the plug and soldered directly onto the 5v line.



Tapping 5v from the Power Pack
 
The 5v for the monitor need to be tapped from the power pack. The simplest way is the splice it in. The joint is then covered with insulating tape.



On a Laser Cut Base



Part List
 
 • Car reverse LCD monitor – ebay

 • Mini wireless keyboard – Amazon

 • USB Power Pack – Amazon

 • Laser cut base – SK Pang Electronics
 
Disclaimer
 
Modifying the LCD monitor at your own risk. This mod removes any over voltage protection to your monitor. Any incorrect voltage applied may damage the monitor.

source:geek.com & skpang-uk